Part Details for CSD18537NQ5A by Texas%20Instruments

This buck converter operates over a 38-V to 42-V input range and delivers 32 V at 5 A.

This supply uses the TPS54160 buck regulator to generate a 5V/0.5A regulated output and an auxilliary 5V/0.2A unregulated output.  A two winding coupled inductor is used to generate the auxilliary output.   The auxilliary output is left floating, and could be used as a -5V output o

The PMP11220 reference design is a high efficiency: high power density: PMBus synchronous buck converter design for programming: and margining the power supply including output voltage.  With a nominal input of 24V meant for industrial bus applications: this design allows for programmable output voltages and minimal power loss: all in a small board space. DCAP2 control mode requires no loop compensation: enabling ease of design: while offering ultra-fast load transient response and use with all MLCC output caps.

This reference design is an isolated flyback that supplies four independent rails; each of them delivers 14 V @ 300 mA. The voltage feedback loop is closed to primary side: therefore: avoiding the optocoupler and increasing the reliability of the converter. The high switching frequency (500 KHz) allows the use of a small transformer and filter components. A digital enable input removes the bias voltage to the controller: therefore reducing the current consumption practically to zero.

This reference design is a tested DC/DC LED driver for high power and high-efficiency dimmable LED luminaires. It is built on a wireless SoC platform which can enable intensity adjustment through analog: PWM dimming and control using any BLE smart device or ZigBee. High bay and low bay LED lighting luminaires are replacing the fluorescent and HID lights as they reduce energy consumption in half and nearly eliminate maintenance costs. Daylight harvesting using the dimming feature combined with ambient light sensor can provide up to an additional 50% energy savings depending on the application. TIDA-01095 provides high efficiency DC/DC conversion: allows dimming: daylight harvesting and enables wireless connected lighting control.

TIDA-01168 参考设计是一款四相、双向直流/直流转换器开发平台，适用于 12V/48V 汽车系统。此系统使用两个 LM5170-Q1 电流控制器和一个 TMS320F28027F 微控制器 (MCU) 进行功率级控制。LM5170-Q1 子系统使用平均电流反馈进行电流控制，而 C2000™ 微控制器则提供电压反馈。这种控制机制不再需要多相位转化器通常需要进行的相电流平衡。基于 LM5170-Q1 的系统可实现高级别集成，减小印刷电路板 (PCB) 面积、简化设计并加速开发。

TIDA-00017 is an eight-channel digital input module front-end reference design for programmable logic controllers (PLCs). It is designed and fully tested to meet IEC61000-4 EMC and surge requirements for industrial automation systems to reduce time to market. The design serializes eight digital inputs: up to 34-volts each: minimizing the number of isolation channels and GPIO pins required of the host interface. Serialized data and control signals are galvanically isolated from the PLC using our high-speed: 4242-volt peak digital isolator technology. The design also includes an over-current protected: isolated power supply providing all necessary module voltages. Full documentation: test results: design files and necessary firmware are also available for this design.

The PMP20742 reference design provides 12V at 5A (60W) from a 36V-60Vdc input with over 94% efficiency. This design uses the UCC2897A active clamp controller along with synchronous rectifiers to achieve very high efficiency.  Typical applications include Power Over Ethernet: Telecom: and Server systems.